Ford Explorer Forum banner

1st 2nd 3rd gen body swaps hellppp???

3295 Views 3 Replies 2 Participants Last post by  markfothebeast
Hi I have a 91 ford exolorer that I built for wheeling straight axle swap lockers gears all the goodies here's my question I have both a 2nd and 3rd gen rolling chassis sitting in my lot with bad engines wondering if I can swap either of the front ends onto my first gen or can I just swap the whole body onto the frame and one ever done this before and can give me some heads up ??

Sent from my SAMSUNG-SM-G891A using Tapatalk
1 - 4 of 4 Posts
I'd imagine up till 01' that the chassis is very similar to the early chassis; front torsion bars, rear leafs, etc. This is on the 97-01 models ive dealt with. Going that far, may as well include a EFI SBC engine.

Sent from my SM-N950U using Tapatalk
I'd imagine up till 01' that the chassis is very similar to the early chassis; front torsion bars, rear leafs, etc. This is on the 97-01 models ive dealt with. Going that far, may as well include a EFI SBC engine.

Sent from my SM-N950U using Tapatalk
Yes every thing does looks some whay similar was thinking about swapping front end from my 98 onto my 91 I seen a couple people done it b4 was looking too see if it's a difficult task

Sent from my SAMSUNG-SM-G891A using Tapatalk
Probably more time consuming than difficult. And back breaking if you don't have a lift.

-Markfothebeast-
(www.youtube.com/markfothebeast)
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top