Joined
·
2 Posts
Hello everyone,
I have a 2015 Explorer, 3.5L, 2WD. Recently, the dash lit up with the wrench light, brake light, abs and traction control lights on.
Did a scan with my ThinkTool and got the fault codes in the attached report. I went ahead and replaced all wheel speed sensors, pig tails to the sensors (rear only) and the ABS module (used module) but the lights are still on.
I've done a real time data read and have found that the two rear speed sensors show twice the vehicle speed while the fronts read the correct speed. I've swapped the sensors but nothing changes.
I'm stumped.
Should I just buy a new module and hope for the best?
Your expert advise is greatly appreciated.
Norman
I have a 2015 Explorer, 3.5L, 2WD. Recently, the dash lit up with the wrench light, brake light, abs and traction control lights on.
Did a scan with my ThinkTool and got the fault codes in the attached report. I went ahead and replaced all wheel speed sensors, pig tails to the sensors (rear only) and the ABS module (used module) but the lights are still on.
I've done a real time data read and have found that the two rear speed sensors show twice the vehicle speed while the fronts read the correct speed. I've swapped the sensors but nothing changes.
I'm stumped.
Should I just buy a new module and hope for the best?
Your expert advise is greatly appreciated.
Norman
