Ford Explorer Forum banner
1 - 1 of 1 Posts

· Registered
2 Posts
Discussion Starter · #1 ·
I recently installed a draw-tite I-command brake controller, but it keeps saying the trailer is not connected. I verified the controller is getting 12v and also verified it gets a voltage when the brake is applied. I also verified it is sending a voltage out to the trailer brakes. I’m pretty sure it’s not the controller. I am not getting that signal at the 7 pin connector. Does anyone know where I can look at a wiring diagram?
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.